Tompkins HomesFinger Lakes pre-construction Start a Project

Tompkins County guide

Incentives, grants & construction loans.

Electrification incentives, a large state-funded ADU grant and the construction loan that pays your builder in stages. Here is what each one is worth, who qualifies and when the money actually arrives.

White farmhouse beside a country road

NYSERDA New Efficient Homes New York (PON 6242)

NYSERDA’s new-construction program supports efficient, all-electric homes with:

  • Enhanced Design Support: up to $5,000 per dwelling unit toward energy modeling and design.
  • Heat pump incentives for new construction on a declining-block basis (amounts step down as program funds are committed).
  • An extra $1,000 per unit in designated Disadvantaged Communities.

Participation usually runs through the builder or energy consultant; enrol during design, not after framing.

NYSEG NYS Clean Heat

For cold-climate air source heat pumps installed by a participating contractor, NYSEG pays roughly $800 per 10,000 Btu/h of heating capacity at 5°F, capped at 120% of the home’s calculated heating load. A typical new 2,000–2,400 sq ft home lands around $2,400–$4,800; a tight Passive House needs less equipment and earns less, but saves more on bills.

INHS / NYS HCR Plus One ADU

Up to $125,000 per project toward an accessory dwelling unit for owner-occupant Tompkins County homeowners with household income at or below 100% of Area Median Income, who commit to renting the unit year-round (no short-term rentals). Funding comes in rounds through INHS; apply before construction. Check your situation with the ADU checker.

Incentive summary
ProgramValueWhoWhen it pays
NYSERDA PON 6242 design supportUp to $5,000 / unitNew all-electric homesDuring design
NYSERDA heat pump incentiveDeclining blockNew constructionAfter installation
DAC bonus+$1,000 / unitDesignated communitiesWith NYSERDA incentive
NYSEG Clean Heat~$800 / 10K Btu/h at 5°FccASHP via participating contractorAfter installation
Plus One ADUUp to $125,000Owner-occupants ≤100% AMIPer program draw schedule

Program terms change between rounds; confirm current amounts with NYSERDA, NYSEG and INHS.

Do not count offsets as cash

Incentives arrive after eligibility review and installation. Your construction loan has to cover the full cost; the rebates come back later.

How a New York construction-to-permanent loan works

  1. Land equity counts. If you own the lot, its appraised value usually counts toward the down payment.
  2. Down payment. Typically 10–20% of total project cost, less any land equity.
  3. Appraisal to plans. The bank appraises the finished home from drawings, specifications and the builder’s contract — itemised bids matter here.
  4. Draws. Funds release in stages (often five: foundation, framing, dried-in, mechanicals, completion) after a bank inspection.
  5. Conversion. At completion the loan converts to a permanent mortgage, often with one closing.

Finger Lakes lenders familiar with rural lots, wells and septic make this easier; a bank that rarely does construction lending may balk at a modular factory deposit or an engineered septic system.

House floor plan drawings
Banks appraise the finished home from plans and an itemised contract.
Barns and autumn hills in upstate New York

Start with what you have

Bring your land details or early sketches.

A parcel address, a rough size and a budget are enough to begin. We check zoning, septic and code, model the real costs, and introduce two or three vetted Tompkins County builders who fit the project.